贵州附近有没有服务

Welcome to shredder, metal shredder, double axis shredder, plastic shredder, wood shredder! fifteen billion six hundred and seventeen million one hundred and fourteen thousand seven hundred and forty-one


News Center

Current location: home page  >  News Center
News Center

How to determine overload operation of double axis shredder equipment?

Click: 0 Time: September 23, 2019

How to determine Double shaft shredder Overload operation of equipment?
Two axis Shredder (also known as shear shredder) can reduce the size of material by shearing, tearing and extruding. The shredder is widely used for waste plastics, rubber, wood and other bulky wastes. More than 30 years of experience in manufacturing such equipment in Europe and the United States has been brought into China. According to the actual situation of the country, it has carried out improvement, research and development, and launched a series of two shaft crushers with mature technology and advanced design. China's early crushing and waste reduction recycling. Capacity processing provides reliable equipment.
The motor of double shaft shredder is a very important component. Special attention as the whole power system needs! The motor is the driving force of double shaft crusher. It is very important to choose the motor. Therefore, in addition to the quality of the equipment, the user should also pay attention to the quality of the motor. The equipment of two shaft crusher should be operated in strict accordance with the operation process. Otherwise, the equipment will be overloaded. How to determine overload operation of double shaft crusher equipment? Let me introduce you to the following:
1. Weigh the belt conveyor of double shaft shredder with belt scale.
Secondly, the contact level gauge is used to indicate the level of the material in the calculation room, that is, to know its load.
Thirdly, the cyclic load of the shielding closed-loop system is obtained from the calculation. Check the current value in the metal crusher circuit. The calculated current is usually controlled at about 85% of the rated current. In the multi-stage production, usually in the closed-circuit system, only the load controlling the particle size of the product is checked, and then the feed quantity and cycle load are calculated.

Related products

Related information